|Material:||PC PS||Screw Diameter:||45mm|
Polycarbonate Ultra Precision Carrier Tape Machine , Embossed Carrier Tape Machine
High-speed particle forming carrier tape machine named particle forming machine for short, it is researched and developed successfully in 2005 by YAOAN. After years of accumulation and improvements, our machine is at a leading position in this industry.
Linear speed of the machine can reach 25m/min as each individual tape; there are two models of our machines: one into 4; one into six. In the market, single layer tape and 3-layer tape are available. The single layer tape is made of PC; the 3-layer tape is made of PC and PS: top layer and bottom layer are of conductive PS; the middle layer is transparency PC.
It is featured by an advanced production technology: Putting plastic raw materials directly in the machine, then extruding--molding --punching – slitting- final winding in mode of complete automation. Since three layers coming into shape at one time; simple process and high efficient utilization rate of raw materials, it has replaced the traditional 2-time forming technology. It greatly reduces the production cost and its production efficiency is dozens of times of the traditional one.
Black Conductive PS Sheet for Carrier Tape
PS Sheet is black carrier tape material with good rigidity and strong toughness
Recommended for packaging of IC electronic components
|PACKAGING||plastic film + stretch film + wooden case + drying agent.|
|DELIVERY||About 100 days (all new parts)|
|SHIPPING||We place and fix the machines well into container and check carefully before closing the container so as to ensure everything is ok for the shipment. (Use steel wire to fix machine and drying agent).
We care each and every point so that our clients could receive the machines in perfect situation.
|PRE-SALE||a. Detailed machine introduction;
b. Suggest suitable turnkey solution as per clients requirements;
c. Provide test production for reference;
|IN PRODUCTION||a. Supply layout drawing to clients for preparation;
b. Suggest suitable building project for pipelines, electric wiring, air pipes, cooling cycle water etc;
c. Keep the clients be informed of the production status;
|AFTER SALE||a. Send engineers to overseas for installation ,commissioning and training;
b. Supply extruding products' material formula, recommend excellent supplier of the raw material per clients' requests;
c. Offer help if any need from clients like spare parts need etc;
d. Supply necessary technical support at request;